The attached document shows how to set up the Automenu Infeed Conveyor along with the Driven Infeed conveyor on the wave solder machines. The document shows where to install the SMEMA and board detect sensors on the machine and infeed conveyor.
ITW EAE Support Center
Related Articles
- Blowholes in (lead-free) wave soldering
- Flux residues on soldered boards
- Assessment of the quality of wave soldered joints
- Flux penetration in connectors or relays
- "Fixed" position of SMDs during re-reflow
- Fat Solderjoints
- Comparing surface isolation resistance measuring data
- Checking solder joint quality after wave soldering
- Selective process
- The case of the ‘high’ solder temperature in Selective
- Are Selective Soldering fluxes reliable?
- Board and joint specifications in relation with lead-free soldering
- Board sagging due to blocked expansion
- Contaminating elements in solder
- Correction of flux density
- Board sagging due to temperature difference between top side and solder side
- Fluxes for (SMD) soldering
- Calculations on flux consumption with a spray fluxer
- Determination of the tin lead ratio by density measurment
- Difficulties and how to avoid them when soldering PCBs with non plated through holes
- General information about sagging of printed circuit boards during the soldering process
- How to keep solderpad holes open in non-plated mounting holes
- Improvement of wave soldering of SOT23 by enlarging soldering pads
- Lead free silver containing solder alloys
- Low tin content in tin-bath solders
- Explication of a circular crack in a topside solder fillet using a model
- Mono-stable and Bi-stable solderjoints
- Reliability of joints in view of the process settings used in wave soldering
- Mechanism of crack formation at the surface of solderfillets