In the attached document three different types of fluxes are tested to determine which are the most reliable in Selective Soldering. The flux types tested are: alcohol (VOC), low VOC and VOC-free fluxes.
ITW EAE Support Center
Related Articles
- Blowholes in (lead-free) wave soldering
- Flux residues on soldered boards
- Assessment of the quality of wave soldered joints
- Flux penetration in connectors or relays
- "Fixed" position of SMDs during re-reflow
- Fat Solderjoints
- Comparing surface isolation resistance measuring data
- Checking solder joint quality after wave soldering
- Automenu Infeed Conveyor and Driven Infeed
- Selective process
- The case of the ‘high’ solder temperature in Selective
- Board and joint specifications in relation with lead-free soldering
- Board sagging due to blocked expansion
- Contaminating elements in solder
- Correction of flux density
- Board sagging due to temperature difference between top side and solder side
- Fluxes for (SMD) soldering
- Calculations on flux consumption with a spray fluxer
- Determination of the tin lead ratio by density measurment
- Difficulties and how to avoid them when soldering PCBs with non plated through holes
- General information about sagging of printed circuit boards during the soldering process
- How to keep solderpad holes open in non-plated mounting holes
- Improvement of wave soldering of SOT23 by enlarging soldering pads
- Lead free silver containing solder alloys
- Low tin content in tin-bath solders
- Explication of a circular crack in a topside solder fillet using a model
- Mono-stable and Bi-stable solderjoints
- Reliability of joints in view of the process settings used in wave soldering
- Mechanism of crack formation at the surface of solderfillets