Part number for a replacement SD card with Firmware Installed is 9-274763
See link below to a video explaining how to replace the SD card on a Future Design MCT4 controller.
The video assumes that you have a replacement SD card with Firmware Installed, and you have a backup of the configuration file, or have received a replacement file for your oven from ITWEAE/Despatch.
MCT4 SD Card Replacement Video
Below and attached is a transcript of the video.
Replacing the SD card on a MCT-4 controller.
There are a few steps to replacing the SD card.
1. Physically install the SD card.
2. Load the Factory Setup from the SD card into the controller.
3. Set the controller back to Icon navigation.
4. Load the Configuration into the controller.
First power off the controller and insert and secure the SD card into the slot on the back of
the controller.
Power up the controller.
From the home screen press menu icon.
Then press Settings.
Press menu again.
Then press Offline, and Yes.
Press menu a third time.
Then press Exit.
Then press Exit application (automatic mode startup), and Yes.
When System Startup, Please Wait… is displayed, double tap just above the box in the
upper left corner.
Press Show Taskbar, then press Quit.
Press Start.
Press Programs, then Windows Explorer.
Double tap on Storage Card.
Then double tap on MCT-4 M A Factory Setup.
Press MCT ¼ DIN.
The controller will delete the controller setup, then copy the new factory setup from the SD
card into the controller.
This process is required to make the controller and SD card setup match for proper
operation.
When a window with Repower Device is displayed, turn the power off to the controller, then
after a few seconds, turn the power back on.
When the home screen is displayed, we need to change the navigation back to icon
navigation.
Press Menu icon.
Press Device.
Press Settings.
Press Menu again.
Then press Set.
And press Navigation.
Select Icon Navigation, then press Home.
The next step is to import the configuration file into the controller.
See link to MCT4 Export-Import Configuration below