This video demonstrates how to change the Despatch DES 2000 Controller used on the Despatch LBB oven from centigrade to Fahrenheit.
Also see the attached written instruction.
ITW EAE Support Center
Related Articles
- Protocol3 Profile & Configuration Backup
- Protocol3 Relay Output Set Up
- Protocol3 Reset to Default
- Protocol3 Calibration Offset
- Protocol3 Temperature Units Change
- Protocol3 Recorder Function
- L91 Calibration
- Setting the Configuration for the DES 2000 Controls
- Fan Motor Replacement in LBB Ovens
- Replacing a Heater in a Despatch Lab Oven
- DES2000 Change Engineering Units
- Airflow Switch Test
- Protocol3 Automatic Start
- Protocol3 Engineering Units
- Changing Engineering Units on Protocol 3 Oven Controller.
- How to Assembly a Despatch Oven Stand
- Purge timer replacement
- Protocol3 Controller Profile Set Up
- Replacing a Protocol with a Protocol 3 Controller
- Replacing the Protocol Plus with the Protocol 3 Controller
- LBB DES2000 Control & L91 High Limit Parameters
- Protocol Manager Setup
- Protocol Plus Profile Programming
- Partlow 1462 Profile Programming
- Protocol3 PID and Control Configuration
- FDC9100 Control Setup
- DES2000 Calibration
- H5CX-N Timer Programming
- L91 Hi-Limit Setup