See attached Video.
Below is a transcript of the audio from the video.
Operating the Protocol 3 control in Manual Mode with event relays activated.
Select Manual Mode and press enter.
To change the setpoint, press the down arrow to highlight the SP value.
Press enter, and the SP value will start to blink.
Use the up and down arrow buttons to change the value.
Press enter to save the change.
To change the high limit setpoint, press the down arrow to highlight the HLSP value.
Press enter, and the HLSP value will start to blink.
Use the up and down arrow buttons to change the value.
Press enter to save the change.
To activate the number 1 event relay, press the down arrow button to highlight the left most square above the PV.
Press enter to put an X in the square.
To start manual mode, press the down arrow button until Start is highlighted.
Press enter and the Manual Mode operation will start.
Note the Manual Mode LED is on, and the relay 1 LED is on.
To stop Manual Mode, press the stop button.
To return to the Select a Mode screen, press the back arrow button.