For wave soldering of SMDs Soltec offers two systems which each have their specific benefits and drawbacks. This sheet will summarize the main points to give assistance in making the right choice.
ITW EAE Support Center
Related Articles
- Cu Erosion in Liquid Soldering Processes
- General Information about Designing for Solderability
- Joint Solderability Demands for Lead-free Wave Soldering
- Physics of Critical Failure Mechanism
- Soldering Machine Capacity
- Solder Spikes on Long Leads
- Skipped Measuring Solderpads in Wave Soldering
- Lean Joints at Wave Soldered Chip Components
- Flux Application Control
- Preheating of PCB's
- Lead-free Compatibility
- Matt Solderjoints after Lead Free Wave Soldering
- Solder Webbing
- Centurion Heat Load
- Skipped Measuring Pads after Wave Soldering
- Soldering Pallets
- Residues on the Soldermask after Wavesoldering
- Solderballs in Wave Soldering
- Solderability in Relation to PCB Design
- The Allowable Permanent Mechanical Load for Solderjoints on PCBs
- Solderable Coatings
- Spikes and Flags on Solderjoints
- The Case of Poor Hole Filling with Lead Free Soldering
- The Effect of Different Fluxes on Soldering of OSP Protected Boards Soldering
- The Effect of Radiation Wave Length on Preheating Result
- The Mechanisms of Solderbridging
- The Origin of Solderball Formation in Wave Soldering
- The Origin of Solderbridging in Dip and Wave Soldering
- Topside Re-melt or Re-reflow
- Wave Process